Description
Description
Learn More
Specs
Fitment
When wiring up accessories that need the wires to go through the firewall, finding a good spot can be a challenge. With the Daystar Firewall Boot, that challenge has become an easy task. All that is needed is to drill a 1.25" diameter hole in the firewall, and then push the boot into place. After that, its as easy as running the wires through the boot and then trim the boot to the desired length. The boot will protect the wires from sharp edges and keep out water leaks and airflow. Works great for tubing and air lines too! Boots are sold individually.
Safely and cleanly run wires through firewalls and bulkheads: Simple to install, drill a small hole and place the boot into the firewall. Run the wires through and you are done! The boot will protect the wires from chafing against sharp edges that could result in shorts.Eliminates air & water leaks: With the Boot in place, it creates a seal that will not allow water or air penetration, keeping wires safe and dry.Fits a variety of wire thicknesses and bundles from 3/8" to 1": Simply trim the boot to the desired size after installed.Works great for tubing and air lines, too!1.25" diameter hole required for installation.
- Shipping Weight: 1lb
- Shipping Dimensions: 8in x 6in x 3in (L x W x H)