Motobilt Frame Chop Rear Bumper and Crossmember; Bare Steel (07-18 Jeep Wrangler JK) | MB1081

Frame Chop Rear Bumper and Cross member for Jeep JK / JKU

The Motobilt Jeep JK Rear Frame Chop Bumper allows for 5 inches of additional ground clearance over the factory receiver hitch. The additional ground clearance you gain is the same as going from a 35 inch tire to a 40 inch.

Jeep JK & JKU Wrangler 2007 to 2018

• 3/16 inch Laser cut and CNC bent steel body
• 3/4 inch Thick laser cut D-Rings that pass through the bumper and welded inside and out
• Gain 2 3/8 inches up and 3 3/8 inches back of ground clearance
• 5 inches of additional clearance over the factory receiver hitch
• Ultra tight design allows the use of a large spare tire
• Full protection from corner to corner
• Includes high strength cross member
• Cross member bolts into factory body mounts then must be welded to the frame
• Works with factory frame or Motobilt jeep JK back half kit
• Cross member includes pre-installed threaded inserts for mounting Motobilt JK frame chop rear bumper
• Threaded mounting holes for JK rear fuel cell skid plate also included

• Ships raw steel. Must be painted or powder coated to prevent rust. 

• Installation video can be found under the Instructions tab
  
• Includes necessary hardware
• Weight: 80lbs (approx.)

Notes:

• Requires cutting of rear frame rails and removal of factory rear cross member
• Cross member must be welded to frame rails.
• A receiver hit will NOT work with this bumper.

Fitment:

• 2007 Jeep Wrangler
• 2008 Jeep Wrangler
• 2009 Jeep Wrangler
• 2010 Jeep Wrangler
• 2011 Jeep Wrangler
• 2012 Jeep Wrangler
• 2013 Jeep Wrangler
• 2014 Jeep Wrangler
• 2015 Jeep Wrangler
• 2016 Jeep Wrangler
• 2017 Jeep Wrangler
• 2018 Jeep Wrangler

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov