Synergy Manufacturing
Synergy Manufacturing JK Stage 4, 6 Inch Suspension System - Right Hand Drive - 8044-60-RHD
- SKU:
- SYN8044-60-RHD
- MPN:
- 8044-60-RHD
- Availability:
- Available To Order
- Shipping:
- Free Shipping
Description
PRODUCT OVERVIEW
- Synergy Jeep JK 6.0 Inch Lift Stage 4 Long Arm Suspension System is for those wanting maximum performance and capability without sacrificing ride quality. It carries over the quality components of the Stage 3 System, but improves upon them by swapping out the Standard Length Control Arms for Adjustable Long Arms and Long Arm Mounting Brackets. This is a 100 percent bolt on system with no welding required. This system will fit 37 inch tires with stock fenders or 40 inch tires with high fenders
Notes: Diesel models will require a set of spacers to be fabricated for installation. The transmission cross member is located further back on diesel models and the front long arm brackets will not sit flush to the cross member - Use Currie anti-rock rear sway bar kit with CE-9901RD2 14 inch end link rods if wanting to run a rear sway bar
- Trimming of skid plate for clearance to front driveshaft will be required with stock driveshaft - aftermarket driveshafts highly recommended
- Relocation of parking brake cables will be required, move from over cross member to under cross member
- Additional bump stop spacing may be required for larger tires if air bump kits are not used
- Springs retain the factory rake of the vehicle where the rear is higher than the front. Vehicle should sit level when loaded. Request one size shorter rear springs to level the vehicle out when unloaded (Recommended rear shocks will be too long with 4.5 inch rear springs. We recommend limit straps, coil retainers, or shorter shocks be used.)
Additional Information
Rear Lift Component: |
Coil spring |
Fitment: |
Direct Fit |
Front Shocks: |
None |
Shocks Series: |
None |
Rear Shocks: |
None |