Wrangler JK (4DR)

Fits Dana 44 Front Axle for the following: 09-11 Wrangler Rubicon JK & Unlimited Rubicon. Fits Dana 35 Rear Axle for the following: 2007 Wrangler JK. Fits Dana 44 Rear Axle for the following: 07-11 Wrangler & Unlimited JK Shipping Weight: 0...

The original EVO MFG C2 Front Axle Reinforcement Gussets are made out of 3/16" laser cut, CNC bent steel and are engineered to seriously beef up your Jeep JK Wrangler's front axle C's. These gussets are a direct fit to the JK Dana 30, Dana 44 and even...

This replacement axle shaft nut fits 2007-16 Wrangler JK/JKU models with Dane 30 or Dana 44 front axles. Fits left OR right side. Sold individually. Axle Model: Dana 30, Dana 44Axle Position: FrontShipping Weight: 0.2lbShipping Dimensions: 4in x 4in x...

The TeraFlex JK U-bolt conversion kit replaces the OEM Rzeppa CV transfer case flange with a standard 1310 CV cardan joint style yoke and U-bolt style connector. The conversion makes u-joint changes easier after breakages. These yokes must be used with a...

Service oil seal for the Rugged Ridge Mega Short SYE. Transfer Case Model: NP231Shipping Weight: 0.05lbShipping Dimensions: 5in x 4in x 4in (L x W x H)

A JE Reel Heavy Duty Front Drive Shaft for JK Wranglers is designed to get you places that a stock shaft just cannot handle. Built for Jeeps with short-arm lifts up to 4.5" and engineered to handle 35" tires, they eliminate the CV joint in lieu of...

The Ten Factory 1310 Rear Driveshaft for the Wrangler JK Unlimited is a perfect solution for getting rid of the factory CV driveshaft and upgrading to a yoke style, or replacing a 1310 driveshaft you broke on your last outdoor adventure. After adding a...

RCV Performance Ultimate CV Axles simply replace your Jeep JK's weak Dana 30 30T U-joint axle shafts with a high-strength constant velocity design. Tests prove Ultimate CV Axles to be twice as strong as OEM axle shafts, and they're just as tough at a...

RCV Performance Ultimate CV Axles simply replace your Jeep JK's weak Dana 44 35 spline (non stock carrier) U-joint axle shafts with a high-strength constant velocity design. Tests prove Ultimate CV Axles to be twice as strong as OEM Jeep JK shafts, and...

This EVO MFG product is designed to increase the Wrangler JK axle housing strength by 30% while incorporating dual seals to prevent debris from entering the axle tubes. Combining these two tried and true technologies will not only increase the strength...

EVO MFG Weld-On front lower control arm skids are constructed using 3/16-inch laser-cut steel plate. One kit is a set of both driver and passenger side skids for front JK axle. Proudly Made 100% In USA. Shipping Weight: 2lbShipping Dimensions: 8in x...

These great kits offer all the components you will need to complete your differential rebuild or ring & pinion installation. Complete with bearings, pinion seals, pinion shims, crush sleeve, pinion nut, ring gear bolts and marking compound. Axle...